MHL Systems Interlocking Snow Plow Blades Including Kennametal Inc. Carbide Tungsten Insert Blades & Specifications
All MHL Interlocking Snow Plow Blades must consist of attached Kennametal carbide tungsten insert specifications. Length & Size to be determined.
The Standard Interlocking Blades use an (MAG/500) wear material that is (3/4″) thick x 4″ wide. It is positioned so that the abrasion-resistant carbide inserts receive maximum protection. The design prevents loss of the carbide inserts and premature failer of the carbide blade.
A unique feature of our Interlocking Carbide Tungsten Insert Snow Plow Blade is the (MAG/500)can be produced with or without embedded carbide casting. These are casting segments that are embedded into areas of the (MAG/500)which provide additional wear life to the section where the blade with castings is installed.
The blades that use embedded carbide castings can be positioned on the snow plow so that additional wear life can be provided in any section of the snow plow. Embedded casting can be installed in areas that tend to wear more quickly providing overall improved wear life.
The top edge of the (MAG/500) material is positioned above the top edge of the carbide inserts, allowing all of the carbide to be consumed along the entire length of the blade resulting in less throw away when the blade is finally spent.
Each 3-ft, 4-ft, 5-ft, & 6-ft blade section is fabricated with (authentic & verified) interlocking joints that provide greater strength at the locations where the blades are joined together. This ensures the blade is uniformly strong throughout it’s length.
The “V-Grooves” for welding are provided for each blade. These also serve as wear indicators and enable the operator or maintenance crew to see at a glance how much carbide is left in each blade.
The 3-ft, 4-ft, 5-ft, & 6-ft blades are either 5″ or 6″ wide and easy to handle when being installed or changed. The plow bolts used are also shorter than the plow bolts used in typical carbide blades with ordinary impact blades, requiring less labor and cost.
Rear-View: Dual four foot interlocking carbide blade with 3/4 inch thick MAG/500 rear-support bar.
Rear Side View:
Carbide dowel segments attached to bottom of (1-1/2″) thick rear [MAG/500] support block.
Note: Both the carbide dowels and carbide tungsten inserts will engage road surface instantaneously.
Rear Bottom View:
Carbide dowel segments (0.54″) Diameter x (0.76″) long x (4) per side attached to rear support block at the same degree point of Kennametal carbide inserts made entirely in the USA!
Right Side View:
Beveled interlocking [MAG/400] attachment end guard showing [MAG/500] interlocking front plate with weld “V” and reverse plow bolt for maximum strength attachment.
Rear View:
Carbide dowel segments are inline with Kennametal carbide snow plow blade
Warranty & breakage guarantee
MHL Systems guarantees all materials against breakage during the complete wear-life of the snow plow blade. If any part of the (MAG/500) Interlocking Material or any welded area breaks while there remains Carbide Tungsten Inserts to be worn, the blade will be replaced along with the adjacent blades which make up the entire length of the snow plow blade.
Example: Should one 4-ft MHL Interlocking Carbide Snow Plow Blade break which is a section of a 12-ft snow plow blade consisting of three (3) pcs x 4-ft, MHL Systems will replace all three (3) Carbide Blades making up the 12-ft original snow plow blade.
This is an unconditional warranty which helps MHL Systems to stand alone as there are no other manufacturers using this warranty policy.